High speed door acceptance debugging details

High speed door acceptance debugging details

With the high speed door production and installation cycle is greatly shortened, the work efficiency is greatly improved. At the same time, the debugging and acceptance of the high speed door after installation is particularly important.

The main debugging of high speed door probably has the following parts. 

Upper and lower limit debugging and detection: in the static state of the door body, press the up button to run the door body upward. After buffering and complete stop, judge whether the lifting height meets the requirements of the user. If the requirements are not met, debug again; After the event, press the down button, and observe whether the end of the door body stays in a natural and decent position after the door body falls completely. 

Emergency stop button performance test: Press the emergency stop button during the operation of the door body to observe whether the door body stops immediately. If it still works normally, check whether the emergency stop button is out of order or damaged. 

Infrared anti-hit performance debugging: in the falling process of the door body, cut off the infrared shooting system to see whether the door body will rebound in time. In the test process, pay attention to their own safety, to prevent the failure of the infrared system caused by damage.

www.v-signindustrial.com