High speed doors reverse operation solution

High speed doors reverse operation solution

1, if the door is installed with radar detection, please make sure that the vibration of the door at the time of operation does not cause the posture of radar detection;

2, if the door is mounted on the controller control, please make sure that the remote control signal receiver is not affected by other unknown data signals and posture, if there is such a thing, must again write code to the signal receiver;

3, determine the bottom maintenance of optical signal transmitter and signal receiver in a line and the installation of solid;

4, ensure that the detection sensitivity of the bottom maintenance optics is adjusted properly;

5, Make sure that when the door is closed, no object block can meet the anti-clamping device at the bottom of the wireless network (bottom);

6, Ensure that the wireless security clamping device at the bottom of the curtain works normally;

7, make sure that the wiring in the wireless security clamp equipment at the bottom of the curtain is appropriate and not loose;

8, Make sure the coiling controller is not activated when the door is closed;

9, Check the error code of the system software and identify the problem according to the error code table.

www.v-signindustrial.com