Method of debugging fast rolling shutter door

Method of debugging fast rolling shutter door

When debugging the fast rolling shutter door limit, first run the fast door door body to the open position and stop. In the process of opening the door, observe the rotation direction of the blue CAM on the limit part, and manually press the limit switch in this direction until it makes a sound. Then immediately tighten the screw on the limit CAM, and fast door close in place. At this time, the red CAM along with blue convex theory in the opposite direction of the pressure limit switch, until a sound, tighten the limit CAM stop screw, the whole limit debugging work is completed.

After the fast door debugging work is completed, try running the fast door door body, check whether the opening and closing limit of the door body is correct, if not, it should be adjusted or fine-tuned again in accordance with the above method immediately until the switch limit of the whole door body reaches the required position.

Note that: when debugging the fast door host limit, the button on the control box should be used to control. When the soft curtain fast rolling door is open and the tube is in place, confirm the limit switch action of the fast door. At this time, the indicator light on the control box should be extinguished. If the indicator light is still not extinguished after the soft curtain fast rolling door is opened and the tube is in place, the limit should be adjusted again.

www.v-signindustrial.com