Safety tips for using industrial doors

1. Please make sure that the door body is in good condition and free of stagnation; only allow the door opener to be installed on a well-balanced door body with a balance spring installed, otherwise it may cause overload damage to the door opener; you must ask a professional installer to check and Install.

2. Installation and wiring must be carried out in accordance with building construction standards and electrical standards, wire diameter ≧ 1.5mm2; the power cord must be connected to a grounded socket, and it is forbidden to remove the grounding lead on the power cord.

3. A mechanical limit device or a buffer booster should be installed at the end of the door guide rail to prevent the door from slipping out.

4. The quick release handle is only used by professionals to install and maintain the operation of the door, and it can only be used when the door is closed.

Lock, this wrench can only be released under the condition that there is no danger of falling under its own weight. It is strictly forbidden to release the wrench during operation.

5. The control box should be installed in a place where the operation of the door can be observed, and it is forbidden to operate the remote control in a place where the operation of the door cannot be seen.

6. Please fix the control box on a wall column 1.4 meters above the ground to prevent children from accidentally touching it. At the same time, keep the remote control well and prohibit children from touching or playing with it to prevent danger.

7. Before repairing and moving the High Speed Automatic Doors opener, please cut off the power supply, and at the same time, make sure that the door is locked and there is no danger of falling due to its own weight.

8. When the door body is running, pedestrians and vehicles are strictly prohibited from passing under the door body or staying under the door body.

9. Do not pull the manual chain when the door is electrically opened or closed.

http://www.v-signindustrial.com